blob: 9c3b7728670ce80e62d71b7145376f1c484bcd14 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
|
/*
* Platform data for Madera codecs
*
* Copyright 2015-2016 Cirrus Logic
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#ifndef MADERA_PDATA_H
#define MADERA_PDATA_H
#include <linux/kernel.h>
#include <dt-bindings/mfd/madera.h>
#include <linux/regulator/madera-ldo1.h>
#include <linux/regulator/madera-micsupp.h>
#include <linux/irqchip/irq-madera-pdata.h>
#include <sound/madera-pdata.h>
#include <linux/extcon/extcon-madera-pdata.h>
#define MADERA_MAX_GPIO_REGS 80
#define CS47L15_NUM_GPIOS 15
#define CS47L35_NUM_GPIOS 16
#define CS47L85_NUM_GPIOS 40
#define CS47L90_NUM_GPIOS 38
#define CS47L92_NUM_GPIOS 16
#define MADERA_MAX_MICBIAS 4
#define MADERA_MAX_CHILD_MICBIAS 4
#define MADERA_MAX_GPSW 2
struct regulator_init_data;
struct madera_micbias {
int mV; /** Regulated voltage */
unsigned int ext_cap:1; /** External capacitor fitted */
unsigned int discharge[MADERA_MAX_CHILD_MICBIAS]; /** Actively discharge */
unsigned int soft_start:1; /** Disable aggressive startup ramp rate */
unsigned int bypass:1; /** Use bypass mode */
};
struct madera_pdata {
int reset; /** GPIO controlling /RESET, if any */
/** Substruct of pdata for the LDO1 regulator */
struct madera_ldo1_pdata ldo1;
/** Substruct of pdata for the MICSUPP regulator */
struct madera_micsupp_pdata micsupp;
/** Substruct of pdata for the irqchip driver */
struct madera_irqchip_pdata irqchip;
/** If a direct 32kHz clock is provided on an MCLK specify it here */
unsigned int clk32k_src;
/** Base GPIO */
int gpio_base;
/** Pin state for GPIO pins
* Defines default pin function and state for each GPIO. The values in
* here are written into the GPn_CONFIGx register block. There are
* two entries for each GPIO pin, for the GPn_CONFIG1 and GPn_CONFIG2
* registers.
*
* See the codec datasheet for a description of the contents of the
* GPn_CONFIGx registers.
*
* 0 = leave at chip default
* values 0x1..0xffff = set to this value
* 0xffffffff = set to 0
*/
unsigned int gpio_defaults[MADERA_MAX_GPIO_REGS];
/** MICBIAS configurations */
struct madera_micbias micbias[MADERA_MAX_MICBIAS];
/** Substructure of pdata for the ASoC codec driver
* See include/sound/madera-pdata.h
*/
struct madera_codec_pdata codec;
/** General purpose switch mode setting
* See the SW1_MODE field in the datasheet for the available values
*/
unsigned int gpsw[MADERA_MAX_GPSW];
/** Accessory detection configurations */
struct madera_accdet_pdata accdet[MADERA_MAX_ACCESSORY];
};
#endif
|