/* platform data for the PCAL6524 16-bit I/O expander driver */ #ifndef _PCAL6524_H_ #define _PCAL6524_H_ #define DRV_NAME "pcal6524-gpio" #define PCAL6524_INPUT 0x00 /* Input port [RO] */ #define PCAL6524_DAT_OUT 0x04 /* GPIO DATA OUT [R/W] */ #define PCAL6524_POLARITY 0x08 /* Polarity Inversion port [R/W] */ #define PCAL6524_CONFIG 0x0C /* Configuration port [R/W] */ #define PCAL6524_DRIVE0 0x40 /* Output drive strength register Port0 [R/W] */ #define PCAL6524_DRIVE1 0x42 /* Output drive strength register Port1 [R/W] */ #define PCAL6524_DRIVE2 0x44 /* Output drive strength register Port1 [R/W] */ #define PCAL6524_INPUT_LATCH 0x48 /* Port0 Input latch register [R/W] */ #define PCAL6524_EN_PULLUPDOWN 0x4C /* Port0 Pull-up/Pull-down Enable [R/W] */ #define PCAL6524_SEL_PULLUPDOWN 0x50 /* Port0 Pull-up/Pull-down selection [R/W] */ #define PCAL6524_INT_MASK 0x54 /* Interrupt mask register [R/W] */ #define PCAL6524_INT_STATUS 0x58 /* Interrupt status register [RO] */ #define PCAL6524_OUTPUT_CONFIG 0x5C /* Output port configuration register [R/W] */ #define NO_PULL 0x00 #define PULL_DOWN 0x01 #define PULL_UP 0x02 #define POWER_ON 1 #define POWER_OFF 0 #define PCAL6524_PORT_CNT 3 #define PCAL6524_MAX_GPIO 23 /* EXPANDER GPIO Drive Strength */ enum { GPIO_CFG_6_25MA, GPIO_CFG_12_5MA, GPIO_CFG_18_75MA, GPIO_CFG_25MA, }; struct pcal6524_platform_data { /* number of the first GPIO */ unsigned int gpio_base; int gpio_start; int ngpio; int irq_base; int irq_gpio; int reset_gpio; uint32_t support_init; uint32_t init_config; uint32_t init_data_out; uint32_t init_en_pull; uint32_t init_sel_pull; struct regulator *vdd; }; #ifdef CONFIG_SEC_PM_DEBUG int expander_print_all(void); #endif #endif