# # MPTCP configuration # config MPTCP bool "MPTCP protocol" depends on (IPV6=y || IPV6=n) ---help--- This replaces the normal TCP stack with a Multipath TCP stack, able to use several paths at once. menuconfig MPTCP_PM_ADVANCED bool "MPTCP: advanced path-manager control" depends on MPTCP=y ---help--- Support for selection of different path-managers. You should choose 'Y' here, because otherwise you will not actively create new MPTCP-subflows. if MPTCP_PM_ADVANCED config MPTCP_FULLMESH tristate "MPTCP Full-Mesh Path-Manager" depends on MPTCP=y ---help--- This path-management module will create a full-mesh among all IP-addresses. config MPTCP_NDIFFPORTS tristate "MPTCP ndiff-ports" depends on MPTCP=y ---help--- This path-management module will create multiple subflows between the same pair of IP-addresses, modifying the source-port. You can set the number of subflows via the mptcp_ndiffports-sysctl. config MPTCP_BINDER tristate "MPTCP Binder" depends on (MPTCP=y) ---help--- This path-management module works like ndiffports, and adds the sysctl option to set the gateway (and/or path to) per each additional subflow via Loose Source Routing (IPv4 only). choice prompt "Default MPTCP Path-Manager" default DEFAULT help Select the Path-Manager of your choice config DEFAULT_FULLMESH bool "Full mesh" if MPTCP_FULLMESH=y config DEFAULT_NDIFFPORTS bool "ndiff-ports" if MPTCP_NDIFFPORTS=y config DEFAULT_BINDER bool "binder" if MPTCP_BINDER=y config DEFAULT_DUMMY bool "Default" endchoice endif config DEFAULT_MPTCP_PM string default "default" if DEFAULT_DUMMY default "fullmesh" if DEFAULT_FULLMESH default "ndiffports" if DEFAULT_NDIFFPORTS default "binder" if DEFAULT_BINDER default "default" menuconfig MPTCP_SCHED_ADVANCED bool "MPTCP: advanced scheduler control" depends on MPTCP=y ---help--- Support for selection of different schedulers. You should choose 'Y' here, if you want to choose a different scheduler than the default one. if MPTCP_SCHED_ADVANCED config MPTCP_ROUNDROBIN tristate "MPTCP Round-Robin" depends on (MPTCP=y) ---help--- This is a very simple round-robin scheduler. Probably has bad performance but might be interesting for researchers. choice prompt "Default MPTCP Scheduler" default DEFAULT help Select the Scheduler of your choice config DEFAULT_SCHEDULER bool "Default" ---help--- This is the default scheduler, sending first on the subflow with the lowest RTT. config DEFAULT_ROUNDROBIN bool "Round-Robin" if MPTCP_ROUNDROBIN=y ---help--- This is the round-rob scheduler, sending in a round-robin fashion.. endchoice endif config DEFAULT_MPTCP_SCHED string depends on (MPTCP=y) default "default" if DEFAULT_SCHEDULER default "roundrobin" if DEFAULT_ROUNDROBIN default "default"