#!/system/bin/sh # Copyright (c) 2009-2013, The Linux Foundation. All rights reserved. # # Redistribution and use in source and binary forms, with or without # modification, are permitted provided that the following conditions are met: # * Redistributions of source code must retain the above copyright # notice, this list of conditions and the following disclaimer. # * Redistributions in binary form must reproduce the above copyright # notice, this list of conditions and the following disclaimer in the # documentation and/or other materials provided with the distribution. # * Neither the name of The Linux Foundation nor # the names of its contributors may be used to endorse or promote # products derived from this software without specific prior written # permission. # # THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" # AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE # IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND # NON-INFRINGEMENT ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT OWNER OR # CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, # EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, # PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; # OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, # WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR # OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF # ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. # target=`getprop ro.board.platform` if [ -f /sys/devices/soc0/soc_id ]; then platformid=`cat /sys/devices/soc0/soc_id` else platformid=`cat /sys/devices/system/soc/soc0/id` fi # # Function to start sensors for DSPS enabled platforms # # VENDOR_EDIT # qiuchangping@BSP 2015-04-16 add begin for gyro sensitity calibration start_sensors() { if [ -c /dev/msm_dsps -o -c /dev/sensors ]; then chmod -h 775 /persist/sensors chmod -h 664 /persist/sensors/sensors_settings chown -h system.root /persist/sensors/sensors_settings chmod -h 664 /persist/sensors/gyro_sensitity_cal chown -h system.root /persist/sensors/gyro_sensitity_cal mkdir -p /data/misc/sensors chmod -h 775 /data/misc/sensors start sensors fi } # qiucahngping@BSP add end start_battery_monitor() { if ls /sys/bus/spmi/devices/qpnp-bms-*/fcc_data ; then chown -h root.system /sys/module/pm8921_bms/parameters/* chown -h root.system /sys/module/qpnp_bms/parameters/* chown -h root.system /sys/bus/spmi/devices/qpnp-bms-*/fcc_data chown -h root.system /sys/bus/spmi/devices/qpnp-bms-*/fcc_temp chown -h root.system /sys/bus/spmi/devices/qpnp-bms-*/fcc_chgcyl chmod -h 0660 /sys/module/qpnp_bms/parameters/* chmod -h 0660 /sys/module/pm8921_bms/parameters/* mkdir -p /data/bms chown -h root.system /data/bms chmod -h 0770 /data/bms start battery_monitor fi } start_charger_monitor() { if ls /sys/module/qpnp_charger/parameters/charger_monitor; then chown -h root.system /sys/module/qpnp_charger/parameters/* chown -h root.system /sys/class/power_supply/battery/input_current_max chown -h root.system /sys/class/power_supply/battery/input_current_trim chown -h root.system /sys/class/power_supply/battery/input_current_settled chown -h root.system /sys/class/power_supply/battery/voltage_min chmod -h 0664 /sys/class/power_supply/battery/input_current_max chmod -h 0664 /sys/class/power_supply/battery/input_current_trim chmod -h 0664 /sys/class/power_supply/battery/input_current_settled chmod -h 0664 /sys/class/power_supply/battery/voltage_min chmod -h 0664 /sys/module/qpnp_charger/parameters/charger_monitor start charger_monitor fi } baseband=`getprop ro.baseband` # # Suppress default route installation during RA for IPV6; user space will take # care of this # exception default ifc for file in /proc/sys/net/ipv6/conf/* do echo 0 > $file/accept_ra_defrtr done echo 1 > /proc/sys/net/ipv6/conf/default/accept_ra_defrtr case "$baseband" in "svlte2a") start bridgemgrd ;; esac start_sensors case "$target" in "msm7630_surf" | "msm7630_1x" | "msm7630_fusion") if [ -f /sys/devices/soc0/hw_platform ]; then value=`cat /sys/devices/soc0/hw_platform` else value=`cat /sys/devices/system/soc/soc0/hw_platform` fi case "$value" in "Fluid") start profiler_daemon;; esac ;; "msm8660" ) if [ -f /sys/devices/soc0/hw_platform ]; then platformvalue=`cat /sys/devices/soc0/hw_platform` else platformvalue=`cat /sys/devices/system/soc/soc0/hw_platform` fi case "$platformvalue" in "Fluid") start profiler_daemon;; esac ;; "msm8960") case "$baseband" in "msm") start_battery_monitor;; esac if [ -f /sys/devices/soc0/hw_platform ]; then platformvalue=`cat /sys/devices/soc0/hw_platform` else platformvalue=`cat /sys/devices/system/soc/soc0/hw_platform` fi case "$platformvalue" in "Fluid") start profiler_daemon;; "Liquid") start profiler_daemon;; esac ;; "msm8974") platformvalue=`cat /sys/devices/soc0/hw_platform` case "$platformvalue" in "Fluid") start profiler_daemon;; "Liquid") start profiler_daemon;; esac case "$baseband" in "msm") start_battery_monitor ;; esac start_charger_monitor ;; "msm8226") start_charger_monitor ;; "msm8610") start_charger_monitor ;; esac